The restriction to this is that any load balancing method used in switch independent configuration must send traffic for a given source MAC address via a single UCS Fabric Interconnect other than in a failover event (where the traffic should be sent to the alternate fabric interconnect) and not periodically to redistribute load. These bonding modes do not require any special configuration on the switch/UCS side.
Support matrixĪll teaming/bonding methods that are switch independent are supported in the UCS Fabric Interconnect environment. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment.
Microsoft Windows Server Version 2008 R2 SP1.The information in this document is based on these software and hardware versions: Microsoft Windows Server Version 2016 and later.Microsoft Windows Server Version 2012 and later.Microsoft Windows Server Version 2008 R2.
Prerequisites RequirementsĬisco recommends that you have knowledge of these topics: This document describes the teaming and bonding options available for common operating systems when using the Cisco Virtual Interface Card (VIC) adapters on the Cisco Unified Computing System (UCS) servers (B-Series, C-Series Integrated, S-Series Integrated, HyperFlex Series) connected to a UCS Fabric Interconnect.
0 kommentar(er)
